HP 3350 - Cisco NAC Appliance 보증 및 지원 정보 - 페이지 15
{카테고리_이름} HP 3350 - Cisco NAC Appliance에 대한 보증 및 지원 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 3350 - Cisco NAC Appliance 19 페이지. Hp 3350 computer to tv connection guide
HP 3350 - Cisco NAC Appliance에 대해서도 마찬가지입니다: 지원 매뉴얼 (19 페이지), 설치 매뉴얼 (14 페이지), 지원 매뉴얼 (19 페이지), 참조 매뉴얼 (30 페이지), 빠른 설정 (1 페이지), 연결 매뉴얼 (1 페이지)
페이지 인쇄
Lithium Battery Caution
WARNING: The PC uses a lithium battery, type CR2032. There is
danger of explosion if the battery is incorrectly replaced. Replace only
with the same, or equivalent, type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
Laser Safety Statement
Class 1 LED Product
The CD-ROM and DVD-ROM drives contain a laser system and are classified as a
"Class 1 Laser Product" under a U.S. Department of Health and Human Services
(DHHS) Radiation Performance standard according to the Radiation Control for
Health and Safety Act of 1968.
Should the unit ever require maintenance, contact an authorized service location.
WARNING: Use of controls, adjustments, or performance procedures
other than those specified in the Getting Started guide may result in
hazardous radiation exposure. To prevent direct exposure to laser
beam, do not try to open the enclosure of the CD-ROM or DVD-ROM.
Laser Product Label
The following label or equivalent is located on the surface of Compaq laser
products:
TV Antenna Connectors Protection
External Television Antenna Grounding
If an outside antenna or cable system is connected to the product, be sure the
antenna or cable system is electrically grounded so as to provide some protection
against voltage surges and built-up static charges. Article 810 of the National
Electrical Code, ANSI/NFPA 70, provides information with regard to proper
electrical grounding of the mast and supporting structure, grounding of the lead-in
wire to an antenna-discharge unit, size of grounding conductors, location of
antenna-discharge unit, connection to grounding electrodes, and requirements for
the grounding electrode.
This label indicates that the
product is classified as a CLASS 1
LASER PRODUCT. This label
appears on a laser device installed
in your product.