HP 6000 - ProLiant - 128 MB RAM 사용자 설명서 - 페이지 18

{카테고리_이름} HP 6000 - ProLiant - 128 MB RAM에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 6000 - ProLiant - 128 MB RAM 20 페이지. F10 utility business pcs
HP 6000 - ProLiant - 128 MB RAM에 대해서도 마찬가지입니다: 지원 목록 (34 페이지), 설정 유틸리티 매뉴얼 (19 페이지)

페이지 인쇄

●

Press and hold any key. If the system beeps, then the keyboard should

be operating correctly.

●

Check all cable connections for loose connections or incorrect

connections.

●

Wake the computer by pressing any key on the keyboard or pressing

the power button. If the system remains in suspend mode, shut down

the computer by pressing and holding the power button for at least four

seconds. Then press the power button again to restart the computer.

If the system will not shut down, unplug the power cord, wait a few

seconds, then plug it in again. The computer will restart if automatic

start on power loss is set in Computer Setup. If it does not restart, press

the power button to start the computer.

●

Reconfigure your computer after installing a non–plug and play

expansion board or other option.

●

Be sure that all the needed device drivers have been installed. For

example, if you are using a printer, you need a driver for that model

printer.

●

Remove all bootable media (diskette, CD, or USB device) from the

system before turning it on.

●

If you have installed an operating system other than the factory-

installed operating system, check to be sure that it is supported on the

system.

●

If the system has multiple video sources (embedded, PCI, or PCI-

Express adapters) installed (embedded video on some models only)

and a single monitor, the monitor must be plugged into the monitor

connector on the source selected as the primary VGA adapter. During

boot, the other monitor connectors are disabled and if the monitor is

connected into these ports, the monitor will not function. You can select

which source will be the default VGA source in Computer Setup.

CAUTION:

is always voltage applied to the system board. You must disconnect the

power cord from the power source before opening the computer to prevent

system board or component damage.

Quick Setup & Getting Started

When the computer is plugged into an AC power source, there

ENWW