HP 800 Series 설치 매뉴얼 - 페이지 18

{카테고리_이름} HP 800 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 800 Series 34 페이지. Version a.01.08
HP 800 Series에 대해서도 마찬가지입니다: 릴리스 노트 (19 페이지)

Using OmniBook Disk Drives

Restoring OmniBook Software

To complete the upgrade process, you'll need to restore your operating system and

any data files that you backed up. This section describes how to restore

Windows 95 and your original OmniBook software.

Windows for Workgroups and your original OmniBook software.

An alternate operating system and your original OmniBook software.

The following procedure describes how to restore Windows 95 and your original

OmniBook software. These steps will delete any software or files you may have

installed or created on your hard disk since the original set-up. Back up what you

would like to save.

The equipment you need are the OmniBook, its ac adapter, a floppy drive, and a

CD-ROM drive (preferably SCSI-type). You also need the Recovery CD-ROM and the

Support Utility floppy disk.

1. Plug in the ac adapter to the OmniBook. Turn off the OmniBook.

2. Connect a SCSI CD-ROM drive (HP part number F1196A) to the OmniBook's

docking/SCSI port according to the CD-ROM drive's instructions. (This requires

a special OmniBook-to-SCSI adapter cable, HP part number F1182A, unless you

are using a docking system.) If you have a non-SCSI CD-ROM drive (parallel

port or PC-card slot), read the README.1ST file on the Support Utilities disk.)

3. Turn on the CD-ROM drive and insert the Recovery CD-ROM —make sure you

use the correct CD-ROM.

4. Connect the floppy drive to the OmniBook. Insert the Support Utility floppy disk

into the floppy drive.

5. Reboot the computer from the floppy by pressing the reset button. (To reboot

from the floppy drive, the System Configuration Utility must have System, Boot

Devices set to FDD First.)

6. When you see a menu of startup options, select Reinstall All Original Files for

Windows 95. Follow the instructions and do not interrupt the file-transfer

process. When the process finishes, your hard disk contains the original files.

This process can take an hour or more.

1-18