HP 8530w - EliteBook Mobile Workstation 설정 및 구성 매뉴얼 - 페이지 5

{카테고리_이름} HP 8530w - EliteBook Mobile Workstation에 대한 설정 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 8530w - EliteBook Mobile Workstation 18 페이지. Hp elitebook mobile workstation
HP 8530w - EliteBook Mobile Workstation에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 빠른 사양 (36 페이지), 사용자 설명서 (15 페이지), 브로셔 및 사양 (4 페이지), 네트워크 매뉴얼 (16 페이지), 사양 (4 페이지), 액세서리 매뉴얼 (2 페이지), 브로셔 및 사양 (6 페이지), 사용자 설명서 (27 페이지), 설정 매뉴얼 (19 페이지), 개요 (16 페이지), 매뉴얼 (12 페이지), 소프트웨어 설치 매뉴얼 (8 페이지), 매뉴얼 (6 페이지), 매뉴얼 (20 페이지), 매뉴얼 (7 페이지), 사용자 설명서 (28 페이지), 빠른 사양 (47 페이지)

a. Select Enabled.

This option enables or disables the ME. It is only used for diagnostic purposes. If there is a

problem where the ME is affected, it can be removed from the system to eliminate it from the

suspect list until root cause is found.

Note that if the ME is disabled, then all AMT is also disabled. The system will not be remotely

manageable.

10) Skip the Intel ME Firmware Local Update Qualifier.

Default Setting

Recommended Setting

11) Skip LAN Controller.

Default Setting

Recommended Setting

This option enables or disables the Intel 82566DM NIC.

If the user needs to disable the NIC, the ME management mode must be set to "None" before

the MEBx will allow the user to proceed (see Step 8). This is to insure that the ME is not in the

middle of a transaction when the NIC is disabled. Disabling the NIC will cause the system to

lose all remote management capabilities.

12) Go into the Intel ME Features Control.

a. Check the Manageability Feature Selection.

Default Setting

Recommended Setting

This option sets the platform management mode: None or Intel AMT.

By default, HP Business Notebooks are set to None.

Note that setting the None option will disable all remote management capabilities.

i. Select Intel AMT option.

ii. Return to previous menu.

b. Return to previous menu.

13) Go into Intel ME Power Control

a. Check the Intel ME ON in Host Sleep States.

Default Setting

Recommended Setting

The options for this setting are:

Mobile: ON in S0

Mobile: ON in S0, S3/AC

: Disabled

(for AMT 2.x)

: Always Open (for AMT 4.x)

: Disabled

(For AMT 2.x; this is not available for AMT 4.x)

: Enabled

: None

(for AMT 2.x)

: Intel AMT (for AMT 4.x)

: Intel AMT

: Mobile: ON in S0

: Mobile: ON in S0, S3/AC, S4-5/AC