Miele HS11 사용 설명서 - 페이지 17
{카테고리_이름} Miele HS11에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele HS11 21 페이지.
Miele HS11에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지)
페이지 인쇄
en
How to replace the AirClean filter
(dia. 31 + 32)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Release the filter grille and raise it
upwards. Grasp the used AirClean
filter by the clean, unsoiled section
(see arrow) and take it out.
^ Replace it with a new AirClean filter.
If you wish to fit an Active AirClean 50
filter or a HEPA AirClean 50 filter
please see "Replacing one type of
exhaust filter with another".
^ Close the filter grille.
^ Close the dust compartment lid.
How to replace an Active AirClean 50
filter or a HEPA AirClean 50 filter
(dia. 33 + 34)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Lift the exhaust filter and remove it.
^ Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
^ Press the exhaust filter change
indicator ~ (dia. 13).
^ After approx. 10 - 15 seconds a thin
red stripe will appear in the left hand
side of the display (dia. 14).
38
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
^ Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum clea-
ner will be fitted as standard with one of
the following exhaust filters (dia. 10):
a AirClean
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
When changing the filter please note:
1. If you wish to replace exhaust filter a
with filter b or c, it is essential that you
remove the filter grille before fitting the
new type of filter (dia. 34).
You will also need to press the exhaust
filter change indicator (dia. 13).
2. If you wish to replace exhaust filter b
or c with filter a, it is essential that you
also fit the filter grille * (dia. 32).
* Filter grille - see "Optional
accessories".
Do not use more than one exhaust
filter at a time.
When to change the thread lifters
The thread lifters on the suction inlet to
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.