Miele HS15 사용 설명서 - 페이지 21

{카테고리_이름} Miele HS15에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele HS15 32 페이지. Vacuum cleaner
Miele HS15에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지), 사용 설명서 (36 페이지), 사용 설명서 (49 페이지), 사용 설명서 (36 페이지), 사용 설명서 (40 페이지), 작동 지침 (25 페이지)

페이지 인쇄

If you wish to use an Air Clean filter,

see "Replacing one type of exhaust

filter with another".

^ Close the dust compartment lid.

Replacing one type of exhaust filter

with another

Depending on model, your vacuum

cleaner will be fitted as standard with one

of the following exhaust filters (dia. 9):

a Air Clean

b ActiveAirClean 50 (black)

c HEPA AirClean 50 (white)

Please note:

1. If you wish to replace the Air Clean

filter a with an ActiveAirClean 50 filter b

or an HEPA AirClean 50 filter c, it is

essential that you remove the filter grille

before fitting the new type of filter (dia.

39). Press the reset button ~ for the

exhaust filter change indicator (dia. 12).

2. If you wish to replace the ActiveAir-

Clean 50 filter b or the HEPA AirClean

50 filter c with an Air Clean filter a, then

it is essential that you also fit the filter

grille *, see dia. 37.

* Filter grille - see "Optional accesso-

ries".

Do not use more than one exhaust

filter at a time.

Maintenance indicator with reset

button (dia. 40)

Some models are fitted with a

maintenance indicator.

The indicator lights up after approx.

50 hours of operation, which is

equivalent to about a year of average

use. The level of soiling of the dust

compartment filter and the exhaust filter

must be checked at this point and if the

filters are replaced, the indicator must

be reset. To do this the vacuum cleaner

must be switched on.

^ Press the reset button.

The maintenance indicator and reset

button will go out and reset to zero.

The indicator can only be reset by

pressing the reset button after the

light has come on. Pressing the

button at any other time will have no

effect.

When to change the battery in the

radio-operated handle

Approx. every 18 months. One 3 V

battery (CR 2032) is required.

The vacuum cleaner can still be

used when the battery has run out or

if there is no battery fitted.

^ Switch the vacuum cleaner on using

the On/Off foot control s. The

Stand-by indicator - on the vacuum

cleaner will light up yellow.

^ Press the restart button on the

vacuum cleaner (dia. 41).

The vacuum cleaner can continue to be

used, but only at maximum power.