Burk Plus-X RP-8 설치 및 운영 매뉴얼 - 페이지 6
{카테고리_이름} Burk Plus-X RP-8에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burk Plus-X RP-8 9 페이지.
You may optionally change the HTTP and Plus-X ports of the Plus-X RP-8 Adapter. The default settings
are recommended.
Burk Technology recommends changing the Plus-X RP-8 Adapter password. The password is used to
log on to the onboard web interface. To change the password, check the Change Password box and
enter the new password in the Password and Confirm fields.
When you are finished, click Save.
Note: If you are unsure what network settings to use, contact your network administrator.
Installation
After entering the configuration settings, you are ready to install the Plus-X RP-8 Adapter in its
permanent location. Simply move the ribbon cable from the Sine RFC-1 to the Plus-X RP-8 Adapter.
Connect the Plus-X RP-8 Adapter to the LAN/WAN, if it is not connected already.
Software Configuration
Now that the Plus-X RP-8 Adapter is installed on the network, you are ready to add the unit to the ARC
Plus using AutoLoad Plus. AutoLoad Plus is included with the ARC Plus, and may also be downloaded
from www.burk.com.
Configuration involves:
Adding the Plus-X RP-8 Adapter unit to the ARC Plus
Mapping Plus-X RP-8 Adapter channels to unused ARC Plus channels
Importing settings from your ARC-16 (optional)
Adding the Plus-X RP-8 Adapter to the ARC Plus
In order for the ARC Plus to recognize the Plus-X RP-8 Adapter , the Plus-X RP-8 Adapter must be
added to the site:
1. Open AutoLoad Plus and connect to the ARC Plus site to which you are adding the Plus-X RP-8
Adapter .
2. From the Edit menu, select Plus-X Devices to open the Plus-X device configuration dialog.
3. Click Add to add the Plus-X RP-8 Adapter to the site.
4. AutoLoad Plus will prompt you to select the device type. Select Plus-X RP-8 Adapter . You may
optionally change the description for the Plus-X device. The description appears in AutoLoad
Plus to identify each Plus-X device.
Plus-X RP-8 Adapter Installation and Operation Manual Rev B
4