Miele K 12820 SD edt 운영 및 설치 매뉴얼 - 페이지 31
{카테고리_이름} Miele K 12820 SD edt에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele K 12820 SD edt 48 페이지. Refrigerator with dynamiccooling
Miele K 12820 SD edt에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (40 페이지), 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (48 페이지)
페이지 인쇄
Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous.
What to do if . . .
. . . the appliance does not get cold.
^ Check whether the appliance has
been switched on. The temperature
display must be lit up.
^ Check that the plug is correctly
inserted into the socket and switched
on.
^ Check that the mains fuse has not
tripped. If it has, there could be a
fault with the refrigerator, the
household electricity supply or
another appliance.
Contact a qualified electrician or the
Miele Service department.
. . . the temperature in the refrigerator
section is too low.
^ Set the required temperature.
^ The Super cool function is still
switched on. Super cool will switch
itself off after 6 – 12 hours.
. . . the compressor is switching in
too frequently and for too long.
^ Check whether the ventilation gaps
have been covered over or become
dusty.
Problem solving guide
^ Check whether the metal grille (heat
exchanger) at the back of the
appliance has become dusty.
^ The appliance door is being opened
frequently.
^ Check that the door has been closed
properly.
. . . the interior lighting in the
refrigerator is not working.
^ Was the refrigerator door left open for
too long? The lighting switches itself
off automatically after approx. 15
minutes if the door is left open.
If this is not the case, then the interior
lighting is defective.
^ Call Miele Service.
The LED lighting may only be repaired
or replaced by a service technician.
There are live electrical components
under the cover. Danger of injury and
damage to the appliance.
Do not remove the cover. If the
cover is damaged or needs to be
removed due to damage, exercise
caution. There are lasers in the
lighting (laser beam class 1M) which
you should avoid looking at directly.
Do not use optical instruments
(magnifying glass or similar) to look
at the lighting either.
31