Miele K 12820 SD edt 작동 및 설치 지침 - 페이지 15
{카테고리_이름} Miele K 12820 SD edt에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele K 12820 SD edt 44 페이지. Refrigerator with dynamiccooling
Miele K 12820 SD edt에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (48 페이지), 운영 및 설치 매뉴얼 (40 페이지), 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (48 페이지)
페이지 인쇄
SuperCool
The SuperCool function can be used to
rapidly reduce the temperature in the
refrigerator section to its lowest setting
(depending on the room temperature).
Switching on SuperCool
SuperCool is particularly recommended
for faster chilling of large amounts of
fresh food or drink.
^ Press the SuperCool button. The
SuperCool indicator light will come
on.
The appliance will then work at full
power to lower the temperature.
Switching off SuperCool
The SuperCool function will switch itself
off automatically after approx. 6 hours.
The indicator light will go out and the
appliance will run at normal power
again.
To save energy, the SuperCool function
can be switched off once food and
drinks are sufficiently chilled.
^ Press the SuperCool button. The
SuperCool indicator light will go out,
and the appliance will continue to
operate at normal power.
SuperCool and DynamicCooling
DynamicCooling m
When the DynamicCooling function is
not switched on, the natural circulation
of air in the appliance will cause
different temperature zones in the
refrigerator as the cold, heavy air will
sink to the lowest section of the
appliance. You should bear this in mind
when placing food in the appliance
(see "Using the refrigerator efficiently").
However, if you are placing a large
amount of food in the refrigerator at any
one time, it is a good idea to switch on
DynamicCooling. This way you can
distribute the temperature inside the
appliance to all areas more evenly so
that all the food will be chilled to about
the same degree.
The temperature is set as normal with
the temperature control.
DynamicCooling should also be
selected when:
– the ambient temperature in the room
is high (above approx. 33 °C), and
– the room humidity level is high.
Switching on DynamicCooling
^ Press the DynamicCooling button m.
The DynamicCooling indicator light
will come on.
15