Miele K 31222 Ui 매뉴얼 - 페이지 4
{카테고리_이름} Miele K 31222 Ui에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele K 31222 Ui 11 페이지.
![Miele K 31222 Ui 매뉴얼](/uploads/products/server2/3443010/3443010.png)
Installing the appliance
Pushing the appliance into its
niche
When pushing the appliance into
its niche make sure that the mains
cable does not get trapped.
Move the appliance carefully on
floors that are sensitive to scratching
to prevent damage.
The appliance feet can break off.
The feet should be almost fully
screwed in when you push the
appliance into the niche.
Useful tip: Loosen the two rear feet by
half a turn before pushing the appliance
in. After pushing it into the niche the
feet will be easier to adjust from the
front (see "Aligning the appliance").
Position the mains electricity cable so
that the appliance can be connected
easily once installed.
Useful tip: To help you push the
appliance into position, tie a piece of
string around the plug to "increase" the
length of the connection cable.
Then pull the cable by the end of the
string through the housing unit.
10841790-04
If the appliance is pushed too far into
the niche, the door may not close
properly once the furniture panel has
been fitted. This can cause ice to
build up, condensate to accumulate
and lead to faults in the appliance.
These can all lead to increased
energy consumption.
Push the appliance into the building-
in niche making sure a gap of 42 mm
is maintained all round between the
appliance body and the front of the
housing unit side walls.
Push the appliance into the niche
until the front edges of the hinges at
the top and bottom are flush with the
front edge of the housing unit side
wall.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.