Allnet ALL1692 빠른 설정 매뉴얼 - 페이지 7

{카테고리_이름} Allnet ALL1692에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allnet ALL1692 8 페이지. Powerline network

페이지 인쇄
ALL1692
Powerline Network
Product installation guide
Important:
Do not plug the device into a power strip or surge protector because these devices may consist
of filter and impair signal. Also avoid plugging the device right next to noisy sources such as cell
phone charger, Halogen light, noisy desktop computer, vacuum cleaner, etc. Both cases result in
poor transmission speed.
To install for the PC local Powerline network
1.
Use the supplied Category 5 Ethernet cable to connect Ethernet Bridge and your PC's Ethernet port.
2.
Plug the Ethernet Bridge to outlet.
3.
You can repeat steps 1 and 2 for connecting many other links depending on your needs
4.
The LINK and LINK/ACT LED indicator light up when you complete the above connection.
5.
The ACT LED indicator starts blinking when the data communication proceeds on power line.
6.
The COL LED indicator flashes when there is a Powerline communication collision.
To share a xDSL or cable modem with Internet access service
1.
Connect one Ethernet Bridge to the broadband router
Plug the Ethernet Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into an available Ethernet port of the Router.
2.
Connect the other Ethernet Bridge(s) to the PC(s) to share the Internet access
Plug the Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into Ethernet port on the PC.
As wireless AP (Access Point) Extender
1.
Connect one Ethernet Bridge to the broadband router
Plug the Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into an available Ethernet port of the Router.
2.
Connect the other Ethernet Bridge to the AP
Plug the Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into the Ethernet port on the AP.
© 2005 . All rights reserved.
P
I
RODUCT
NSTALLATION
.
Page 7
G
UIDE