Miele GAS COMBISET CS 1011 작동 및 설치 지침 - 페이지 13

{카테고리_이름} Miele GAS COMBISET CS 1011에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele GAS COMBISET CS 1011 48 페이지. Gas combiset
Miele GAS COMBISET CS 1011에 대해서도 마찬가지입니다: 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (48 페이지), 변환 지침 (40 페이지)

페이지 인쇄

Turning on

^ To turn on the burner, press the

control knob down to pass the

resistance, then release the pressure

and turn it counterclockwise to the

largest flame symbol. The ignitor will

"click" and ignite the gas.

If the burner does not ignite or the

flame goes out, turn the control knob to

"ß". Try again after a few seconds.

If the burner still won't ignite after the

second attempt, turn the control knob

to "ß" and see "Frequently asked

questions".

^ Adjust the knob to the desired

setting.

Regulating the burners

The inner and outer burners are both

controlled by one control knob. There is

a stop at the 6 o'clock position that

requires you to press the knob down

while turning it, in order to get from the

high flame zone to the low flame zone.

^ To reduce the flames from a high to

low setting, turn the control knob

counterclockwise until resistance is

felt. Press the knob down to pass the

stop, then release the pressure and

set the combiset to the desired

setting.

^ To increase the flames from a low to

high setting, turn the control knob

clockwise until resistance is felt.

Press the knob down to pass the

stop, then let go. Now set the

combiset to the desired setting.

Since the outer portion of the flame is

much hotter than the center, the flame

should be set so that its tips do not

spread beyond the sides of the pan.

Flames which extend beyond the sides

of the pan are hazardous.

Turning off

^ Turn the knob clockwise to "ß".

This stops the gas flow and turns off the

combiset.

Use