Miele KM 412 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Miele KM 412에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele KM 412 20 페이지. Ceramic hobs; ceramic contact grill; open grill; deep fat fryer
Miele KM 412에 대해서도 마찬가지입니다: 사용 설명서 (24 페이지), 사용 설명서 (28 페이지), 설치 지침 매뉴얼 (20 페이지), 사용 설명서 (24 페이지)
페이지 인쇄
Building in
Fit wall units and the cooker hood
before fitting the appliance, to avoid
damaging it.
The veneer or laminate coatings of
worktops (or adjacent kitchen
units) must be treated with 100 °C heat
resistant adhesive which will not
dissolve or distort. The worktop
upstand must be heat-resistant.
Ideally the appliances should be
installed with plenty of space on
either side. There may by a wall at the
rear and a wall or tall units at one side.
On the other side, however, no unit or
divider may stand higher than the
appliance (see illustrations).
An electric fryer must not be
installed next to a gas hob, as the
gas flames could ignite the fat in the
fryer. It is essential to maintain a safety
distance of at least 288 mm between
these two appliances.
Due to the heat radiated by the
appliance and to allow cooking
fumes to dissipate it is essential that
a minimum safety distance a is
maintained between the worktop
cut-out and adjacent kitchen units,
e.g. a tall unit, as follows:
KM 400, KM 402, KM 403, KM 412
KM 418 = 40 mm
KM 408-1 = 50 mm
KM 410 / KM 411 = 250 mm
There must be a minimum safety
distance of 50 mm between the hob
and a back wall.
Warning and Safety instructions
recommended
not recommended
not allowed!
3