Allnet FW8888 빠른 설치 매뉴얼 - 페이지 4

{카테고리_이름} Allnet FW8888에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allnet FW8888 12 페이지. Low power utility server

페이지 인쇄

4.2 IDE connector and Compact Flash card socket :

4.2.1 IDE connector:

IDE connector supports standard ATA 33/66/100 devices.

The pin 20 is removed intentionally for the purpose of

dummy-proof.

IDE connector also supports 40 pin IDE DOM

(disk on module).

IDE connector is designed to use primary channel and

default is set to Slave.

4.2.2. Compact Flash card socket:

Type II CF card connector supports type II CF (compact

flash) memory cards.

Please be noted that it is designed as Primary IDE Master,

so CF card does not support hot plug feature as normal CF

card readers.

4.2.3. CF card Master/Slave Setting:

CF card can be configured as Primary IDE Master / Slave by

CF_SET_J1.

CF_SET_J1

Jumper Position

4.3 SATA1 and SATA2:

SATA1 and SATA2 are designed to connect SATA devices via

7-pin SATA cable. Please refer to the following figure for SATA pin

definition.

Description

CF Card is set to IDE Master (Default)

CF Card is set to IDE Slave

4.4 Default Jumper Settings:

4.4.1 Clear CMOS:

Disable: 1-2 pin short (default)

Clear CMOS: 2-3 pin short

CCMOS1

Jumper Position

4.5 Other Onboard Connectors:

4.5.1 PWRON4P and PWRCON4PS:

PWRCON4P: provides 12V and 5V DC. PWRCON4P

is reserved for supplying 5V and 12V for SATA hard drive

or IDE devices.

PWRCON4PS: provides 12V and 5V DC. PWRCON4PS

is reserved for supplying 5V and 12V for IDE DOM

(Disk On Module)

Please check the following pin-out definition for using PWRCON4P

and PWRCON4PS as power source of your device.

4.5.2 VGA1 and USB3 pin 1 : alignment:back panel VGA

and USB ports are default connected via cables to

main board VGA1 and USB3 respectively.

Description

Disable (Default)

Clear CMOS