ALLNIC AUDIO L-10000 소유자 매뉴얼 - 페이지 10

{카테고리_이름} ALLNIC AUDIO L-10000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLNIC AUDIO L-10000 17 페이지. Otl/ocl line-stage preamplifier

GAIN STAGE BALANCING USING THE CURRENT METERS - IMPORTANT!

There is one current meter for each channel on the front of the L-10000 (See Figure 4). These

meters indicate the status of the current supply to the gain tubes in the L-10000 OTL/OCL. If the

gain stages are set up and functioning properly, the needles of the meters should be in the centre

between the two parallel lines in the middle of each meter.

The meters have two functions, but initially, and from time to time as may be necessary (this

should be very infrequently, if ever, for example, when replacing the 300B tubes), they are used

to balance the outputs of the third gain stage tubes for the right and left channels.

Using a small, flat blade screwdriver, turn the screw head located immediately above each of the

meters on the L-10000's face (see Figure 4) clockwise and counter-clockwise until the meter's

needle is centred between the parallel lines in the middle of the meter. The goal is to have the

needles of both meters in the centre position between the two parallel lines. Please be patient;

it could take some time to get the balance, but once set, it should rarely, if ever, move.

The Allnic Audio L-10000 OTL/OCL is now ready for operation. At this point, you can power on

your sources and, finally, your stereo power amplifier or mono-blocks.

OPERATION

From this point on, operation is straight-forward. All functions are controlled from the front panel

or the remote control. Of course, BE CAREFUL about differences in gain between your sources.

Generally, disc players and tuners will have greater gain than phono stages. That means the

volume setting for listening to your turntable might be too high for listening to digital disks or

streaming devices.

To avoid surges to the speakers, it is best to change from input to input only with the "operate"

button set to mute (the light above the button will not be illuminated when the button is in the

"mute" position).

When you are finished listening, turn off your stereo power amplifier or mono-block amplifiers.

Then turn off the L-10000 OTL/OCL by depressing the power button on the front panel. The

power switch on the left side panel should stay in the "on" position – this will keep key circuitry

warm, and your L-10000 OTL/OCL will be ready to play when the soft-start turns on the L-10000

OTL/OCL next time you want to listen. Turn off your sources last.

There is one current meter for each channel on the front of the L-10000 (See Figure 4). These

meters indicate the status of the current supply to the gain tubes in the L-10000 OTL/OCL. If the