ALLO STM 빠른 설치 매뉴얼 - 페이지 8

{카테고리_이름} ALLO STM에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLO STM 9 페이지. Sip threat manager
ALLO STM에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (11 페이지)

STM Appliance 1.0

Accessing the WebUI

The user can connect to the device via management vlan to access WebUI during initial

setup. The management vlan configured on the device, is accessible via the LAN/WAN ports

& is made assigned with the default ip address '192.168.100.1'

Use the procedure given below to access the WebUI,

1. Connect the LAN port of the STM to a PC.

2. Assign the IP Address 192.168.100.2 to the PC. Set the Netmask as 255.255.255.0.

Now you can access the device from the browser using the URL as given below

https://<192.168.100.1>

Note:

The WebUI has been made accessible only via HTTPS. The Device WebUI Server has been

made to use Self signed PKI Certificate, Thus the browser will prompt to accept the self

signed certificate generated by the device on accessing the WebUI.

The recommended browser for accessing STM WebUI is Mozilla Firefox.

Configure the STM Device IP Address from the "Device Settings" Page as per your local

network range. Verify the IP address set to STM from the dashboard page. Once the user

assigns the STM Device IP Address successfully, he can access the device using that IP

address further.

Now he can disconnect the PC and connect the LAN Port to the PBX/PBX Network that

needs to be protected.

Note:

The UI allows the administrator to configure the management vlan ip address. In case if the

user has changed the management vlan ip address, he needs to assign the corresponding

network address to his PC for the management access subsequently.

Quick Installation Guide V2.0