Dialighting IB50-MH 사용자 설명서 - 페이지 3

{카테고리_이름} Dialighting IB50-MH에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dialighting IB50-MH 6 페이지. 50w led moving head beam

페이지 인쇄

0-225

Pan/Tilt

226-235

Speed

236-245

246-255

0-019

020-029

030-039

040-079

080-099

100-119

Special

120-139

140-159

160-179

180-199

200-219

220-239

240-255

Max to min speed

Blackout by movement

Blackout by all wheel changing

Empty

Color change normal

Color change to any position

Color & gobo change to any position

Empty

Motor reset

Internal program 1

Internal program 2

Internal program 3

Internal program 4

Internal program 5

Internal program 6

Internal program 7

Internal program 8

2. 2. 2. 2. S S S S afety

afety

afety I I I I nstructions

afety

nstructions

This device has left the factory in perfect condition. In order to maintain this condition and to ensure a

safe operation, it is absolutely necessary for the user to follow the safety instructions and warning

notes written in this user manual.

If the device has been exposed to temperature changes due to environmental changes, do not switch

it on immediately. The arising condensation could damage the device. Leave the device switched off

until it has reached room temperature.

This device falls under protection-class I. Therefore it is essential that the device be earthed.

The electric connection must carry out by qualified person.

The device shall only be used with rate voltage and frequency.

Make sure that the available voltage is not higher than stated at the end of this manual.

Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,

replacement of the cable must be done by an authorized dealer.

Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the

power cord by the plug. Never pull out the plug by tugging the power cord.

During initial start-up some smoke or smell may arise. This is a normal process and does not

necessarily mean that the device is defective, it should decrease gradually.

Please don't project the beam onto combustible substances.

Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for

smooth air flow, so there should be no shelter for fans and ventilation for heat radiation.

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the

manufacturer or his service agent or a similar qualified person in order to avoid a hazard.