ABB ACQ580-820A-4 빠른 설치 매뉴얼 - 페이지 12

{카테고리_이름} ABB ACQ580-820A-4에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACQ580-820A-4 20 페이지.

12 EN – Quick installation guide

Step

Ground the input cable shields (if present) 360 degrees at the cabinet lead-through.

Connect the twisted shields of the input cables and separate ground cable (if

present) to the cabinet grounding busbar.

For option +B051:

• Step drill carefully sufficiently big holes to the lead-through clear plastic

shroud for the cables to the connected.

• Align the holes in the vertical direction according to the alignment holes in

the shroud. Smooth the hole edges.

• Remove the plastic sheeting from both sides of the shroud.

• Attach the cables firmly to the cabinet frame to prevent chafing against the

hole edges.

For option +B051: Put the conductors of the input cables through the drilled

holes in the clear plastic shroud.

Connect the input power cable conductors to the L1/U1, L2/V1 and L3/W1

connection busbars.

For option +B051: Move the lead-through clear plastic shroud along input

cables to its final position. Install the front clear plastic shroud.

Install the upper front cover.

Remove the cardboard protective covering from the drive module air outlet.

For option +B051: Cut the hole for the lead-through clear plastic shroud in the

side clear plastic shroud. Install the side and top clear plastic shrouds to the

drive module.

Install the air baffles

See figure

on page

hardware manual.

Connect the control cables

See figure

on page 18.

1. Ground the outer shields of all external control cables 360 degrees at the cabinet lead-

through.

2. Ground the pair-cable shields of external control cables to a grounding clamp below

the control unit. Leave the other end of the shields unconnected or ground them

indirectly via a high-frequency capacitor with a few nanofarads, eg, 3.3 nF / 630 V.

3. Connect the conductors to the appropriate terminals of the control unit. See page 13.

4. Wire the optional modules if included in the delivery.

Task (input cables)

and Guidelines for planning the cabinet installation in the

Figure

Page