ALLOWANCE 100 사용자 설명서 - 페이지 6

{카테고리_이름} ALLOWANCE 100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLOWANCE 100 15 페이지. Television time manager

페이지 인쇄

For example: If you wanted the weekly time allowance for child one to be two hours and fifteen minutes you

would press the keys listed below. Suppose also that only one child's allowance was to be set up.

Key(s) Pressed

215

ENTER

After the ENTER key that set the weekly time allowance for child one is pressed the display will flash "C2".

This indicates that the access code for child two should be set. To do this, follow step 4 above. If you do not

want to set the access code for child two or if only one child will be using the allowance press the enter key

when the display is flashing "C2" as outlined in the table above. Up to four access codes and time allowances

can be set up in this manner.

USING PARENT MODE

To enter PARENT MODE press the keys that correspond to the Master Parental Access Code. For example if the

Master Parental Access Code was 1478 press the keys 1478. As the fourth key is pressed the TV Allowance

recognizes the Master Parental Access Code and enters PARENT MODE (The parent light comes on and the TV

Allowance sounds a beep).

Once PARENT MODE is entered you can change or look at access codes, weekly time allowances, time

remaining in the weekly time allowances, lockout intervals, the rollover feature and the time of day. In addition,

upon exiting the PARENT MODE the TV will remain on until turned off or until the enter key is pressed. This

allows parents access to unrestricted viewing.

The table below lists the functions that are available in PARENT MODE. The first column of the table is the key

pressed and the second column of the table is a description of the function. The sections following give a

description of each function.

Function Key

CODE

ALLOW

FORCE

LOOK

CLEAR

Note: When the 4 digits pressed to get into PARENT MODE do not match the Master Parental Access Code or

any child's Access Code then the TV Allowance will sound an error tone.

4.1. CODE KEY – CHANGE A CHILD ACCESS CODE

In Parent mode, to change the access code for a child you must press the CODE key followed by one of the

digits 1, 2, 3 or 4 (corresponding to which child's access code is being changed). After entering one of the

Action Taken

This causes the display to show 0215

This sets the weekly time allowance for child one to two hours and

fifteen minutes and causes the display to flash "C2".

This exits the initial setup procedure and places.

The bell tone will sound, the parent LED will light up, and the TV

will come on if it is plugged in and turned on.

To exit the Parent Mode and turn off the TV press ENTER twice

more. The first ENTER exits Parent Mode and the second turns of

the TV.

Function Description

Set (or Change) a Child Access Code

Set (or Change) a Child's Weekly Time Allowance

Change the time remaining in a child's account.

Look at Weekly Time Allowances, time remaining in Weekly Time

Allowances, and Child Access Codes.

Change the Time of Day