ABB ACS880-01 Series 빠른 설치 및 시작 매뉴얼 - 페이지 6
{카테고리_이름} ABB ACS880-01 Series에 대한 빠른 설치 및 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACS880-01 Series 17 페이지. Industrial drives
ABB ACS880-01 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 빠른 설치 매뉴얼 (14 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (18 페이지)
페이지 인쇄
R6...R9
3d
3c
3c
3b
3b
3b
4.
Frames R1...R3: Install the control cable grounding shelf.
Frames R4, R5: Install the EMC shroud (a). Frames R4...R9: Install the shroud (b).
5.
In frames R6...R9, install the side plates if removed. Attach the cables outside the drive mechanically.
6.
Ground the motor cable shield at the motor end. For minimum radio frequency interference, ground the motor cable
shield 360 degrees at the cable entry of the motor terminal box.
10. Connect the control cables
Make the connections according to the application. Keep the signal wire pairs twisted as near to the terminals as possible
to prevent inductive coupling.
1.
Cut a hole into the rubber grommet and slide the grommet onto the cable.
2.
Ground the outer shield of the cable 360 degrees under the grounding clamp. Keep the cable unstripped as close to the
terminals of the control unit as possible. Ground also the pair-cable shields and grounding wire at the SCR1 terminal.
3.
Tie all control cables to the provided cable tie mounts.
R8, R9 if parallel cables
R6: M5×25 Torx T20;
M4×20 Torx T20
R7: M5×35 Torx T20
R8,R9: M5×25 Torx T20
2 N·m (17 lbf·in)
3a
M5×25 Torx T20
2 N·m (17 lbf·in)
M4×8 Torx T20
1.5 N·m (13.3 lbf·in)
a
R4: M4×8 Torx
T20 (2 pcs),
M4×10 Torx T20
(1 pcs)
2 N·m (17 lbf·in)
R5: M4×8 Torx
T20
2 N·m (17 lbf·in)
6
M5×12 Torx T20
2 N·m (17 lbf·in)
b