Alloy Home MH4 매뉴얼 - 페이지 8

{카테고리_이름} Alloy Home MH4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alloy Home MH4 12 페이지. Electrical heating thermostat

screen. When the detected indoor temperature ≥ the set temperature, heating turns off

and the

icon disappears.

•

Room Temperature Control, Floor High Temperature Limit Mode

If the

Temperature Control, Floor High Temperature Limit Mode. When the

it indicates the current temperature display is the indoor ambient temperature. When

the detected indoor temperature ≤ the set temperature by -2.5°C, the heater will turn

on and the

icon will display. When the detected indoor temperature ≥ the set tem-

perature, the heater will turn off and the

buttons simultaneously will switch the displayed temperature the floor temperature and

the

icon will display. When the temperature is higher than 45°C (113°F), the heater

shuts off and the

When the floor temperature reduces to 40°C (104°F), the heater will turn on and the

FLOOR LIMIT

icon disappears.

Temperature Unit Switching

In the shutdown interface, long pressing

settings.

Z-Wave Network Inclusion and Exclusion

Press and hold

not included in a network, "- - -" displays on screen. Press

learning mode to get a node ID. If inclusion is successful, a node ID will display on the screen.

After inclusion, turn the device off and then on. The device is now ready to be operated by

the Z-Wave network controller/gateway. Note: Follow the same steps to exclude the device

from the network.

icon displays on the screen, it indicates the system is in Room

FLOOR LIMIT

icon displays on the screen to avoid overheating the floor.

to enter the Z-Wave Network inclusion and exclusion menu. If the device is

icon will disappear. Pressing

and

switches the temperature unit

once and the device enters into

icon displays,

and