Dialogic IMG 1004 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Dialogic IMG 1004에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dialogic IMG 1004 8 페이지. Integrated media gateway
Dialogic IMG 1004에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (10 페이지)

Dialogic IMG 1004 빠른 시작 매뉴얼
GCEMS software
The GCEMS Server will need the most current system software in order to configure and provision the IMG 1004. The most
current software can be obtained from the Dialogic Technical Support website.
1. Go to the Dialogic Technical Support Website at
2. Logon and go to the BBS Software download site. As noted above, a support contract with Dialogic is needed to access
this site. Within this site will be two software binary files with the following format. Download the latest version of these
files.
IMG_10.5.x.135.bin
IMGUserInterface_10.5.x.135.bin
NOTE: If you do not have a support contract with Dialogic, then the software supplied to you on the Software CD can be
used.
3. Refer to the topics under the following headings in the Online Documentation or the supplied CD to install the GCEMS
software
IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup
IMG 1004-Installation and Setup Guide > IMG 1004-Setup > Starting GateControl EMS

Connecting DATA0 Port

1. The port DATA that is located on the rear of the IMG 1004 is a Fast-Ethernet port and is dedicated to VoIP Bearer traffic
as well as signaling. The DATA port can be on the same IP network as the management network or can be connected to a
separate network. See the following topics in the online documentation for more information.
2. The IP addresses for these ports will be assigned through the ClientView GUI. See the ClientView section below for more
information.
IMG 1004-Installation and Setup Guide > IMG 1004-Hardware Installation

Connecting TDM Signaling and Bearer Ports

The Bearer ports (Interface Offsets) 0-4 are connected to the TDM network. Each Bearer Port can have signaling and
bearer channels configured on it.
ISDN D-channels and B-channnels are brought in over the Bearer Ports.
CAS signaling and voice channels are brought in over the Bearer Ports.
Dialogic Corporation
IMG 1004 Quick Start Guide
installation.
http://www.dialogic.com/support
Part # 07-8724-00
Page 6 of 7