ALLpaQ Packaging Group Genesis 1000 운영자 사용 설명서 - 페이지 3

{카테고리_이름} ALLpaQ Packaging Group Genesis 1000에 대한 운영자 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLpaQ Packaging Group Genesis 1000 13 페이지.

1.3 Fitting port position plates to bag

ALLpaQ recommend that all 3D bags used in conjunction with it bioprocess range of containers

should be ﬁtted with a small plastic support disc when ﬁlled. Some bags may be pre ﬁtted with a

similar disc however if this is not the case please contact ALLpaQ immediately before use.

To ﬁt the disc simply squeeze the tubing (Fig 3.1) and slide towards the centre of the disc as

shown (Fig 3.2).

1.4 Fitting the bag

When ﬁtting a bag the operator can access the base of the container over the erected side panels

(Fig 4.1).

The bag can be located from this position.

Fig 4.1

Fig 4.2

Bag ﬁlling can commence, according to manufacturers recommendations.

ALLpaQ recommend foam dunnage for all shipping containers (see 2:4 Fig 4.5)

Fig 3.1

Fig 4.3

Fig 4.4

Fig 4.5

Manual V1 - (Sept 14

Fig 3.2

Please ensure that the clamp on the

outlet tube is closed/open prior to

operation according to manufacturers

instruction. (Fig 4.3)

Feed the outlet tubing through the

drain hole in the base of the

container (Fig 4.1).

It may be helpful to pull the tubing by

accessing the chamber via the front

door on the base of the unit (Fig 4.4).

Once the tubing has been fed

through, the white disc will locate in

the bottom drain hole of the base

unit (Fig 4.2).

The end of the drain tubing should

be ﬁtted to the tube clamp for easy

access (Fig 4.5)

2012)