ALLpaQ Packaging Group Genesis 250 운영자 사용 설명서 - 페이지 7

{카테고리_이름} ALLpaQ Packaging Group Genesis 250에 대한 운영자 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLpaQ Packaging Group Genesis 250 13 페이지.

2.2 Unfolding the container for use

When lifting the lid of a 1000 Litre container it is recommended that two people be involved in the

operation.

Fig 2.1

Lock the front and ﬁnal sidewall into position (Fig 2.7).

Replace the lid in a reversal of the description see instruction 2.5 below (Fig 5.1).

2.3 Fitting port position plate to bag

ALLpaQ recommend that all 3D bags used in conjunction with it bioprocess range of containers

should be ﬁtted with a small plastic support disc when ﬁlled. Some bags may be pre ﬁtted with a

similar disc however if this is not the case please contact ALLpaQ immediately before use.

For full instructions refer to instruction 1.3

Fig 2.2

Fig 2.4

Fig 2.5

Fig 2.6

Fig 2.7

Manual V1 - (Sept 14

Fig 2.3

2012)

Hold and lift the

black handles at the

four corners of the

lid and move

towards the centre,

to the open position

(Fig 2.2).

Using both hands

pull the side panel

towards you to erect

the ﬁrst sidewall (Fig

2.4).

Repeat this action

for the opposite

panel (Fig 2.5)

Complete the same

action with the rear

panel making sure

the wall clicks into

position (Fig 2.6)