Dialogic Media Board DMV1200BTEP 빠른 설치 카드 - 페이지 2

{카테고리_이름} Dialogic Media Board DMV1200BTEP에 대한 빠른 설치 카드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dialogic Media Board DMV1200BTEP 2 페이지. Media board

페이지 인쇄

Installing a PCI Board

Remove

Cover

Plate

Computer

Chassis

PCI Slot

ISA Slot

6. Replace and tighten the retaining screw to secure the

board firmly in the chassis slot (if applicable).

7. Connect the RJ-48C jack on the board bracket to the

switch using a digital telephone crossover cable.

8. Select a new PCI slot and repeat steps 3-7 for each

board you are installing.

9. Use the CT Bus cable to connect the board(s) you are

installing to other boards in the system.

Pinout for RJ–48C Jacks

Network Interface

on PCI Bracket

Cable Connector

RCV_RING

Pin 1

RCV_TIP

Chassis Ground

XMIT_RING

XMIT_TIP

Chassis Ground

NOTE: Your system may include both CT Bus and SCbus

boards. To connect both board types, you must install a CT

Bus/SCbus Adapter on one of the CT Bus boards in a

system. See the CT Bus/SCbus Adapter Quick Install Card

for installation details about the Adapter and the bus

cables. Contact your sales representative to order an

Adapter.

10. Install CT Bus Termination Jumpers only on boards

located at each end of the CT Bus cable. See Physical

Description.

11. Replace the chassis cover plate when finished and

reconnect the power cords.

12. Turn the power to the chassis ON.

CAUTION: If your BIOS is set to use Plug and Play

technology and there are ISA boards in your system, an

IRQ conflict can be created if a DM3 board is assigned the

same IRQ as an ISA board. This could cause the machine

to stop responding. You can prevent this by entering the

BIOS and reserving the appropriate IRQs (those used by

your ISA boards) for ISA use only.

Installing the CT Bus Cable

PCI

Board

After Installing Hardware

After installing the hardware, proceed with the system

software installation as described in the system software

documentation (if applicable). For technical specifications

and product information, see the Dialogic website at

http://www.dialogic.com/products.htm.

Warranty and Return

For specific warranty information for this board, refer to the

Warranty section of the Products page, located at this URL:

http://www.dialogic.com/warranties/.

Dialogic provides technical support for its products through a

network of value added distributors who are trained to answer

technical questions on installing and configuring Dialogic

products. If you are unsure how to contact your support

channel, please call Dialogic in the United States at 973-967-

6600 (9am-5pm EST) and we will assist in obtaining the

appropriate support channel. Outside the United States please

refer to

http://www.dialogic.com/support/contact

local contact information. Dialogic also provides direct

support via Dialogic

details of direct support from Dialogic please refer to:

http://www.dialogic.com/support/DialogicPro.

To return a board for warranty repair or any other returns,

please refer to the following:

http://www.dialogic.com/support/hwfaults. To return a board

for warranty repair, please refer to the following:

http://www.dialogic.com/support/hwfaults. For all other

returns, contact your vendor or Dialogic Customer Support

(for more information, see

http://www.dialogic.com/support/contact/

CT Bus

Colored

Cable

Stripe

(Pin 1)

Note:

Your CT Bus cable may

have a different number

of connectors (drops).

Information

Warranty Period

Contacting Technical Support

to obtain

Pro™ Services agreements. For more

Returning a Product

Sales Assistance

If you have a sales question, please contact your

local Sales Representative or the Regional Sales Office

for your area. Address, telephone and fax numbers, are

available at the Dialogic website located at:

http://www.dialogic.com/contact.htm. To purchase Dialogic

products, please refer to the following website to locate the

appropriate supplier. http://www.dialogic.com/purchase.htm.

All contents of this document are furnished for informational use only and are

subject to change without notice and do not represent a commitment on the part

of Dialogic Corporation or its subsidiaries ("Dialogic"). Reasonable effort is

made to ensure the accuracy of the information contained in the document.

However, Dialogic does not warrant the accuracy of this information and

cannot accept responsibility for errors, inaccuracies or omissions that may be

contained in this document.

INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION

WITH DIALOGIC

PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED,

BY ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY

RIGHTS IS GRANTED BY THIS DOCUMENT. EXCEPT AS PROVIDED

IN A SIGNED AGREEMENT BETWEEN YOU AND DIALOGIC,

DIALOGIC ASSUMES NO LIABILITY WHATSOEVER, AND DIALOGIC

DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY, RELATING TO

SALE AND/OR USE OF DIALOGIC PRODUCTS INCLUDING LIABILITY

OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR

PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY

INTELLECTUAL PROPERTY RIGHT OF A THIRD PARTY.

Dialogic products are not intended for use in medical, life saving, life

sustaining, critical control or safety systems, or in nuclear facility applications.

It is possible that the use or implementation of any one of the concepts,

applications, or ideas described in this document, in marketing collateral

produced by or on web pages maintained by Dialogic may infringe one or more

patents or other intellectual property rights owned by third parties. Dialogic

does not provide any intellectual property licenses with the sale of Dialogic

products other than a license to use such product in accordance with

intellectual property owned or validly licensed by Dialogic and no such

licenses are provided except pursuant to a signed agreement with Dialogic.

More detailed information about such intellectual property is available from

Dialogic's legal department at 9800 Cavendish Blvd., 5

Quebec, Canada H4M 2V9. Dialogic encourages all users of its products to

procure all necessary intellectual property licenses required to implement

any concepts or applications and does not condone or encourage any

intellectual property infringement and disclaims any responsibility related

thereto. These intellectual property licenses may differ from country to

country and it is the responsibility of those who develop the concepts or

applications to be aware of and comply with different national license

requirements.

Dialogic, Diva, Eicon, Eicon Networks, Eiconcard and SIPcontrol, among

others, are either registered trademarks or trademarks of Dialogic. Dialogic's

trademarks may be used publicly only with permission from Dialogic. Such

permission may only be granted by Dialogic's legal department at 9800

Cavendish Blvd., 5th Floor, Montreal, Quebec, Canada H4M 2V9. Any

authorized use of Dialogic's trademarks will be subject to full respect of the

trademark guidelines published by Dialogic from time to time and any use of

Dialogic's trademarks requires proper acknowledgement. The names of actual

companies and products mentioned herein are the trademarks of their

respective owners.

Floor, Montreal,