AllPondSolutions 600-HO 매뉴얼 - 페이지 6
{카테고리_이름} AllPondSolutions 600-HO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions 600-HO 17 페이지. Aquarium hang-on filter
페이지 인쇄
Please Ensure:
The power supply must be earthed and fused at
·
3amps.
You regularly inspect the cable for damage and
·
deterioration.
Do not connect to any voltage other than that
·
stated.
You consult a qualified electrician if in doubt about
·
any aspects of wiring.
Important: The power supply must be earthed and
fused at 3amps. Regularly inspect the cable for damage
and deterioration. Consult a qualified electrician if in
doubt about any aspects of wiring.
INSTALLATION & USE
Please read the below instructions carefully before
beginning to set up your filter. DO NOT CONNECT THE
UNIT TO THE MAINS UNTIL SET UP IS COMPLETE AND
UNIT IS FILLED WITH WATER.
Important installation information:
When installing your filter, the minimum water level in
·
the tank should be no more than 6 cm (2.25 inches)
below the aquarium rim.
The inlet pipe should NOT be positioned too close to
·
an air stone, aeration device or the output valve to
avoid reducing the effectiveness of the filter.
Firstly, unpack the unit and identify all parts using the
parts diagram in this instruction manual.