AllPondSolutions 700IF+ 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} AllPondSolutions 700IF+에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions 700IF+ 16 페이지. Aquarium internal filter with uv

TROUBLESHOOTING

No Filter Operation / Slow Flow Rate

Slow Flow Rate

1. Always ensure the power has been turned on.

2. Follow the maintenance section. Ensure the water outlet is not blocked.

3. Locate the impeller and shaft and inspect for damage and clear the ﬁttings

and parts of any waste build-up.

4. Check that your impeller and shaft are seated correctly.

5. Ensure the impeller is free of any type of blockage and can rotate freely

inside the motor head.

Slow Flow Rate

1. Locate the impeller and shaft and inspect for damage and clear the ﬁttings

and parts of any waste build-up.

2. Check that your impeller and shaft are seated correctly.

3. Ensure the impeller is free of any type of blockage and can rotate freely

inside the motor head.

The Light on My 700IF+ Isn't Working

If the UV indicator at the front of the ﬁlter is not lighting up follow these

troubleshooting steps:

1. Clean the UV indicator.

2. Check that you have power from the mains supply.

3. Please check for signs of damage or water ingress to

quartz sleeve and bulb area. You might need to

replace your quartz sleeve and/or O-Rings if that's the

case. Ensure that all O-rings are in place and well lubricated.

5. If the above does not solve the issue replace the UV bulb.

6. If you ﬁnd that the UV light is still not operational after the bulb replacement,

the UV ballast may have developed a fault and you will need to contact the

supplier of your unit to obtain replacement parts.

Please remember that UV bulb should be replaced every 6 months.