AllPondSolutions PF-12000 매뉴얼 - 페이지 4

{카테고리_이름} AllPondSolutions PF-12000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions PF-12000 19 페이지. Pressurised pond filter, bio-mechanical filtration, built in steriliser, large filter volume, pressurised closed system, simple user friendly operation

페이지 인쇄

ELECTRIC

This unit comes complete with a generous supply of 3 core cable, however

should any additional cable be required, the use of an approved waterproof

cable connector with a proper rating is essential. A cord rated for less amperes

or watts than the appliance rating may overheat.

Please Ensure:

The power supply must be earthed and fused at 3amps.

You regularly inspect the cable for damage and deterioration.

Do not connect to any voltage other than that stated.

You consult a qualiﬁed electrician if in doubt about any aspects of

wiring.

A residential current device (RCD) is used for additional safety

You have complied with Local Electricity Authority regulations if

permanently installing to the mains supply.

Please Ensure: The power supply must be earthed and fused at 3amps.

Regularly inspect the cable for damage and deterioration. Consult a qualiﬁed

electrician if in doubt about any aspects of wiring.

CHOOSING YOUR FILTER LOCATION

The pressure of your unit depends on many factors such as location (height

and distance from pond), power and location of connected pump (L/H),

stock density and hose dimensions. To enhance pond water quality, we

recommend considering these factors to ensure maximum eﬃcience and

avoid low return pressure.

Ensure the PF is located at least 2 metres from the pond edge.

The PF is suitable for burying up to the head rim of the unit. Please ensure

you can still access the body for maintenance purposes. Burying the unit

will help reduce the distance between the ﬁlter and the pond and provide

higher return water pressure.