AllPondSolutions AP-1.5-KIT 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} AllPondSolutions AP-1.5-KIT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions AP-1.5-KIT 13 페이지. Aquarium air pump

To ensure your new aquarium ﬁlter is set up and running correctly, and to prevent any

accidental damage or injury, please read and follow the below instructions carefully before

using your product.

SAFETY

IMPORTANT!

Disconnect the mains electricity supply before attempting any installation /

maintenance of any kind. Do not attempt to modify this unit in any way and only use the

recommended parts for replacement.

· Always check air pump for any damage prior to use. It is essential that you NEVER

submerge the air pump - the unit must be used in a dry environment.

All connections must be earthed. Do not connect to any voltage other than that stated.

The power cord of this appliance cannot be replaced; if the cord is damaged, the

appliance should be discarded. Never cut the cord.

Do not carry or pull the unit by its electrical cable.

Do not use this unit if it has a damaged cord or plug, if it is malfunctioning or it is dropped

or damaged in any manner.

Do not yank cord to pull plug from outlet. Grasp the plug and pull to disconnect. Always

unplug an appliance from an outlet when not in use.

Do not attempt to modify this unit in any way and only use the recommended parts for

replacement.

Before installing, maintaining or handling your equipment, or before placing your hands in

your aquarium, ensure that the unit is disconnected from the electricity supply.

Always unplug any electrical devices when not in use.

Carefully examine your air pump after installation. Do not plug in the unit into the mains if

there is water on any parts not intended to be wet.

If the air pump falls into the water, DO NOT reach for it. First unplug the unit and then

retrieve it. If the electrical components of the appliance get wet, unplug the appliance

immediately.