AllPondSolutions AP-3-KIT 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} AllPondSolutions AP-3-KIT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions AP-3-KIT 13 페이지. Aquarium air pump

2. Remove the old diaphragm(s) from the valve housing and

then ﬁt the new diaphragms.

3. Make sure the air pump is correctly put back together and

securely fastened with the screws.

TROUBLESHOOTING

No Air Is Being Produced

1. Ensure that the air pump is plugged

2. Follow the maintenance section. Ensure that there are no blockages in the air hose

assembly and that all valves allow air passage. Check that the air hose is not kinked.

3. Turn the pump up. The control knob is located on the front of the pump.

4. Remove air hose. Unplug appliance and inspect the diaphragm for tears or rips. Any

opening in the diaphragm will make it impossible for the pump to produce air for aeration

purposes.

1. Placement of your air pump can greatly aﬀect the amount of noise it makes. Try suspending

the noisy air pump at, or above water level to reduce the resistance of water on the air pump.

IMPORTANT!

Ensure the air pump is not positioned so it could either fall in the water or get

splashed. Air pumps are not designed for exposure to water, and touching a wet air pump

in.