AllPondSolutions FPP- 4500 매뉴얼 - 페이지 5

{카테고리_이름} AllPondSolutions FPP- 4500에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions FPP- 4500 14 페이지. Fountain eco pond pump

INSTALLATION & USE

The All Pond Solutions FPP pump range is designed to be used with the

included fountain kit as a standalone system within a pond but can be used to

circulate water, pump to and from a separate ﬁltration system or water features

using suitable ﬂexible hose (ﬂexible hosing sold separately).

Please read the below instructions carefully before beginning to set up your

pump. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS

COMPLETE AND UNIT IS FILLED WITH WATER.

1. Connect the required

attachments - Choose the required

fountain attachments.

2. Position the unit - fully submerge

your FPP unit. Place it on a level and

sturdy surface at the bottom of your

pond, this is to avoid silt entering the

pump causing excessive wear and increasing pump guard cleaning.

3. Adjust the fountain head - make sure it is above surface of the pond. Adjust

the extendable pipe until desired height has been achieved.

IMPORTANT!

Ensure that the pump's fountain does not empty water out of

pond.

4. When installing your FPP as a standard water pump connect your outlet pipe

using a clamp / bracket and ensure this is tight and secure. The included

hosetail is designed to ﬁt 20-40mm hose.

If not using the fountain connect your outlet pipe to either your ﬁlter, water

feature or alternative location.

5. Connect your FPP pump to the mains - Connect the unit to the mains using a

residual current device (RCD) for additional safety.

6. Switch on your unit at the mains - turn on the operation by switching on the

unit at the mains.