AllPondSolutions EF1+ 매뉴얼 - 페이지 18
{카테고리_이름} AllPondSolutions EF1+에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions EF1+ 20 페이지. Aquarium external filters
Check that your impeller and shaft are seated correctly and n o t damaged
in any way.
Ensure the impeller is free of any type of blockage and can rotate freely inside the
motor head.
Priming Problems
If air remains trapped in the system after initial setup, please restart the process and
follow these guidelines:
Check all hosing and pipework is connected correctly, air tight a n d
unrestricted.
Reinsert the Inlet / Outlet tap (part 1) to be sure it is securely installed a n d set to open
(lever down).
Ensure all Inlet / Outlet pipework connection points are fully submerged whilst
priming.
Fill the EF filter body (part 5) with aquarium water, this will aid the priming o f the EF.
Prime the EF without the surface skimmer (part 15) attached - this can be re- attached
after priming.
Ensure the EF filter body (part 5) is not over stocked with media and foam a s this can
restrict water flow and affect the priming function.
The Water In My Aquarium Is Dirty
Causes:
The beneficial bacteria have not yet established in your new filter.
Your filter is not the correct size for your aquarium set up.
You have too many fish for your size filter.
Your filter media may be dirty.
Solutions:
Your fish tank can take up to 3 weeks to successfully cycle. You may also want
to add a bacteria start treatment to your tank to speed up this process.
You may need to upgrade to a larger filter. For reference, you s h o u l d allow 1 gallon
of water per 1 inch of fish in your aquarium.
Follow the instructions in the maintenance section above.
If you have not yet done so, you may also need to carry out more regular
water changes in your tank.