ABB BRIT-90-35-200 운영 매뉴얼 - 페이지 6

{카테고리_이름} ABB BRIT-90-35-200에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB BRIT-90-35-200 14 페이지. Transformer bushings with rip- insulation, voltage class 35 kv

페이지 인쇄

ABB Power Grids Ltd.

Figure 1 shows the bushing components. The main insulation of the bushing consists of an insulating body

(pos. 1) made from under vacuum resin impregnated paper with aluminium layers for capacitive grading

and wound on the copper or brass rod (pos. 2).

A porcelain insulator (pos. 3) is pressed to the flange (pos. 4) with a spring system in the top part of the

bushing (pos. 5). To protect the insulator body from moisture, the space between the body and the porcelain

insulator is filled with the compressible dry filler Micagel.

For the measurement of the capacitance, the dissipation factor and PD of the bushing a self grounding test

tap (pos. 6) is installed in the main flange. Due to a design of the test tap the last aluminium layer is grounded

automatically in use if the cover is screwed upon it.

Never open the test tap during the operation!

5 Marking

On the every bushing flange there is a designation plate with following information:



manufacturer's trade mark;



country;



the bushing's identifying code;



dimensional drawing number;



production serial number;



voltage and current rating;



weight;



maximum installation angle in relation to vertical;



and tgδ

;



and tgδ

6 Packaging, transportation and storage

6.1 Shipment

Bushings are transported in wooden boxes rigidly fixed with elastic packing cradles. The top of the box is

marked with "Top". Bushings are shipped and stored horizontally. The low part of bushing is protected

from moisture by a plastic case with a silica gel bag inside.

While storing plastic cases and silica gel bags are checked for consistency once in six months. A change of

indicating silica gel color from blue to pink points at its silica gel's being damp. In this case the whole silica

gel must be changed.

6.2. Storage rules

Bushings can be stored outdoors only in weatherproof places or indoors. Storage time (short, medium or

long period, see Table 2) should be taken into consideration.

Caution! Generally the moisture protection of the bushing must be mounted all times.

GKSL 680205.021 RE

Rev. 2, 26.09.2019