Miller 300939 소유자 매뉴얼 - 페이지 19

{카테고리_이름} Miller 300939에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 300939 24 페이지.

Table 6-1. Maximum Strip Speed (IPM)

Strip Roll Diameter (in.)

Table 6-2. Maximum Strip Speed (MPM)

Strip Roll Diameter (mm)

6-3. Coolant Flow Sensor

When a Strip Drive 100 motor is attached to a SubArc Digital Interface, the coolant flow sensor relay contacts (accessible on the terminal strip inside

the interface) are enabled. The coolant flow sensor relay has normally open contacts and requires closure for the system to operate. If a coolant flow

switch is provided with the cladding head cooling system, connect the coolant flow switch leads to "Coolant Flow" and "Common" on the terminal strip.

To allow operation of the system if a coolant flow switch is not used, install a jumper wire between the "Coolant Flow" and "Common" terminals. See

SubArc Digital Accessories Owner's Manual (OM-267 533) for information on connections to the terminal strip.

OM-254238 Page 15