Miller 394F 소유자 매뉴얼 - 페이지 20

{카테고리_이름} Miller 394F에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 394F 44 페이지. Dual wire feeder

General Terms:

Sequence

Preflow

Start

Crater

Postflow

Feeder Set Up

Auto Thread

OM-222 394 Page 16

Selecting Sequence will allow setting of preflow, start, crater, and postflow times and parameters.

Setting a time value for gas flow prior to arc start.

Provides voltage/arc adjust, wire feed rate, and time value for modified arc starts (which is only

adjustable with the optional PDA with File Management/WaveWriter software).

Allows setting of voltage/arc adjust, wire feed rate, and time value for arc ends.

Setting a time value for gas flow after arc end.

Allow selection of Sequence and trigger functions.

Method of jogging wire without holding jog or trigger switch. Pressing Jog and Retract simultaneously

will automatically feed wire. Default setting is 192 at a feed rate of 700 ipm (these values can be

changed using a PDA with File Management/WaveWriter software). Pressing jog, purge, or trigger

switch will terminate the auto-threading feature.