Miller AA40GB w/OCP 소유자 매뉴얼 - 페이지 16
{카테고리_이름} Miller AA40GB w/OCP에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller AA40GB w/OCP 24 페이지.
Miller AA40GB w/OCP에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지)
페이지 인쇄
3-6. Plug Connections
2
3-7. Threading And Feeding Welding Wire
Tools Needed:
Pressure
Adjust
JOG
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press power source Jog push
button until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
OM-223 426 Page 12
1
3
Welding Power Source
ON
PURGE
V
OFF
JOG
POWER
Turn on power at welding power source.
Pressure
Adjust
WOOD
Press Jog push button until wire comes
out of gun. Feed wire to check drive roll
pressure. Adjust knob enough to pre-
vent slipping.
1
Weld Control
2
Motor Control Cord (Not
Supplied)
Cord is available in 20 ft (6.1 m),
30 ft (9.1 m) or 50 ft (15.2 m)
lengths.
3
Motor/Drive Assembly
To make connections, align key-
way, insert plug, and tighten
threaded collar.
804 104-C
Hold wire tightly to keep it
from unraveling.
6 in
(150 mm)
Pull and hold wire; cut off end.
Cut off wire. Close cover.
Ref. 804 391-A / Ref. 156 798 / 802 914