Miller Coolmate 1.3 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Miller Coolmate 1.3에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Coolmate 1.3 28 페이지. Recirculating coolant system for water-cooled gtaw torches and gmaw guns
Miller Coolmate 1.3에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄

5-1.

GTAW Connections

11/16 in.

wrench

crescent wrench

Do not move or operate unit where it

could tip.

To prevent overheating, make sure cooling

unit is positioned so there is 12 in. (305 mm)

of unrestricted airflow on sides of unit.

NOTICE – If welding power source has a

water valve, do not connect hoses to water

valve. Connect hoses as shown.

nutdriver

1 Coolant Out Hose

chippinghammer

2 Coolant In Hose

OM-257811 Page 12

wirecutter

frontcutter

�

Complete Parts List is available at www.MillerWelds.com

SECTION 5 – INSTALLATION

Fittings have 5/8-18 left-hand threads. Con-

nect hoses with proper fittings as shown.

Some power sources may require a TIG

block.

3 Coolant Tank Cap

4 115 Volt AC Grounded Receptacle

A dedicated circuit capable of carrying 15

amperes and protected by fuses or circuit

breakers is recommended. Recommended

fuse or circuit breaker size is 15 amperes.

Operation:

Fill tank with proper coolant. Use table in

Section 4-5 to select proper coolant. Main-

tain coolant level at approximately 1 in. (25

mm) below top of filler neck. Connect hoses

as shown. Unit turns on when plugged in.

For correct water cooled torch adapters, see

the Coolmate Series Options And Accesso-

ries page.

805500-A