Miller Deltaship 502 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Miller Deltaship 502에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Deltaship 502 28 페이지. Arc welding power source

Miller Deltaship 502 소유자 매뉴얼

3-9. Connecting To Weld Output Terminals

Tools Needed:
3/4 in (19 mm)
Y Turn off power before connecting to
weld output terminals.
Y Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.
Notes
4
1
Do not place
anything between
weld cable terminal
and copper bar.
2
3
Correct Installation
1
Weld Output Terminal
2
Supplied Weld Output Terminal Nut
3
Weld Cable Terminal
4
Copper Bar
Remove supplied nut from weld output ter-
Incorrect Installation
minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar. Do not place anything between weld
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.
OM-227 512 Page 11
803 778-A