Miller EnPak A30 빠른 매뉴얼 - 페이지 7

{카테고리_이름} Miller EnPak A30에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller EnPak A30 12 페이지.

Getting Started

Before Starting Your EnPak

Make sure the emergency brake is on and there is power to the EnPak remote panel. This could be a

master switch or EnPak switch. Make sure to check all fluids and belts before starting.

First Start of the Day

Turn the Engine Control Switch to the Start position and release. The EnPak warning will beep and

automatic starting sequence begins. Allow the EnPak engine to warm up before work begins.

Engine Stop

Turn Engine Control Switch to OFF position.

To enable the auto start/stop feature place the Engine Control Switch in the Auto Start/Stop position.

To disable the auto/start top feature, place the Engine Control Switch in the Auto-Speed position.

Turn the Compressor On or Off

To turn the compressor on or off, position the compressor switch in the I (on) or O (off) position.

Battery Charge Mode

To enable the battery charge/crank assist feature, place the Charge/Weld switch in the charge

position and place the process switch in the position matching voltage of the battery being charged.

Chassis Power Mode

To enable the Chassis Power feature, place the Charge/Weld switch in the charge position and place

the process switch in the Chassis Power 12 V position. When using the EnPak to keep the truck

battery charged for multiple lights or other items, use the Chassis Power mode for high amperage

applications.

Weld Mode

To enable a weld mode, place the Charge/Weld switch in the weld position and place the process

switch in the position matching the desired weld process.

Page 7