Miller EnPak A60GBHW 빠른 시작 매뉴얼
{카테고리_이름} Miller EnPak A60GBHW에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller EnPak A60GBHW 4 페이지.
페이지 인쇄
Service Locations
1
Engine Filters
and Fill Points
2
Fuel Pump
3
Hydraulic Pump
4
Compressor
Filters and
Fill Point
5
Remote/Manual
Switch
6
CB-1 Location
7
Cool Pak CB
Location
8
Fuse and Relay
Panel
9
Brush Location
10
Serial Number
Location
Control Panel
1
Start Button
2
Home Screen
3
Adjust Control/Select Button
Turning On Unit
Safety interlock signal must be provided to turn unit on. Refer to
section 5-8 in Owner's Manual for more information.
Press the Start button to turn the Control Panel on. A splash screen
will display for a few seconds before the Home screen is displayed.
Press the Start button to turn on the engine. Use the soft buttons to
open the Weld, Battery, and Settings screens.
Turning Off Unit
Press the Start button to turn the unit off.
Turning Off Control Panel
Hold the Start button for 2 seconds to turn the control panel off.
Control panel will display "Shutting Down" and turn off after a few
seconds along with stopping the engine if running.
A60GBHW
Quick Start Guide
1
2
3
9
WARNING
READ INSTRUCTIONS.
• Read and follow all labels and the Owner's Manual carefully before installing, operating or
servicing unit. Read the safety information at the beginning of the manual and in each section.
5
6
7
4
2
1
4
10
3
1
8