Miller I-24 소유자 매뉴얼 - 페이지 19
{카테고리_이름} Miller I-24에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller I-24 36 페이지.
페이지 인쇄
3-9. Motor Start/Burnback Control
Tools Needed:
Non-Conductive
1/4 in
1
2
3
To change wire feed starting speed
proceed as follows:
Turn Off unit and welding power
source.
Remove wrapper.
1
Motor Board PC1
2
Motor Start Control
Potentiometer R73
Remove protective white rubber
cap before making adjustment.
Adjust potentiometer R73 using a
small nonconductive screwdriver.
Rotate potentiometer clockwise to
increase time it takes the motor to
ramp up to speed.
3
Burnback Potentiometer R42
Remove protective white rubber
cap before making adjustment.
Adjust potentiometer R42 using a
small nonconductive screwdriver.
Rotate potentiometer clockwise to
increase burnback time.
Reinstall wrapper.
801 925-C / 192 653
OM-186 895 Page 15