Miller ICE-40C 소유자 매뉴얼 - 페이지 20

{카테고리_이름} Miller ICE-40C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-40C 40 페이지. Air-cooled torches for plasma arc cutting
Miller ICE-40C에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (38 페이지)

페이지 인쇄
Miller ICE-40C 소유자 매뉴얼

4-11. Installing Alternative Plug

This procedure is necessary if the unit is to be connected to a 208/230 VAC
receptacle that requires a plug that is different from the supplied plug.
Tools Needed:

4-12. Setting Gas/Air Pressure

2
3
1
4
Setting Gas/Air Pressure
Place Output Control in
Gas/Air Set Position
Power Switch On
Set Controls
1
Power Switch
Place power switch in On position
OM-2239 Page 16
6
1
7
Requires
90−150 PSI Supply
(620−1035 kPa)
Turn On Gas/Air Supply
2
Output Control
Place output control in Gas/Air position.
3
Pressure Gauge
2
3
4
5
Rear of Unit
Set To 75 PSI (517 kPa) For Cutting
Or 55 PSI (379 kPa) For Gouging
Adjust Pressure
On Unit
4
Gas/Air Pressure Adjustment Knob
Adjust pressure to 75 psi (517 kPa) on
pressure gauge by pulling and turning knob.
Push knob in to lock setting.
Select desired cutting output with Output
Control.
1
Supplied 230 VAC Plug
Cut cord close to plug.
2
Alternative Plug (230 VAC
Plug Shown)
3
Input (Black Lead)
(Brass) Terminal
4
Input (White Lead)
(Brass) Terminal
5
Ground (Green) Terminal
6
Outer Shell
7
Cord Grip
Strip cord jacket back enough to
separate conductors.
Strip conductors enough to make
good contact with plug terminals.
Make plug connections and reinstall
outer shell and cord grip. Tighten
assembly screws onto shell. Do not
overtighten.
Ref. 801 305-A / 801 611
Ref. 803 219 / 803 221
Select Desired
Amperage To
Begin Cutting