Miller ICE-40C 소유자 매뉴얼 - 페이지 25

{카테고리_이름} Miller ICE-40C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-40C 40 페이지. Air-cooled torches for plasma arc cutting
Miller ICE-40C에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (38 페이지)

페이지 인쇄

1. Section 8 − Parts List

5-7. Sequence Of Piercing Operation

Connect work clamp to a clean, paint-free

location on workpiece, as close to cutting

area as possible.

Rotate torch to upright position

approximately 90

to surface.

When arc has pierced through

workpiece, start cutting.

Set air pressure to 75 PSI

(517 kPa) for cutting.

Maintain approximately 90

torch

position to surface, and continue

cutting.

The pilot arc starts immediately

when trigger is pressed.

Hold torch at an angle to the

workpiece. Raise trigger lock and

press trigger. Pilot arc starts.

Release trigger. Postflow continues for

approx. 20 seconds after releasing trigger;

arc can be instantly restarted during postflow

by raising trigger lock and pressing trigger.

Ref. 803 640-A / 801 400-B

OM-2239 Page 21