aquanta AQ-CA-G100-ESL 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} aquanta AQ-CA-G100-ESL에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aquanta AQ-CA-G100-ESL 12 페이지. Smart water heater controller for natural gas water heaters

페이지 인쇄

2. Attach the second Temperature Sensor to the cold-water inlet pipe using two of the

supplied Cable Ties. Wrap one of the Cable Ties around the cold-water pipe and slide

the narrow end through the slot. Position the Temperature Sensor on the cold-water

pipe as close as possible to the water heater and under the Cable Tie, then pull the

Cable Tie as tight as possible. Place a second Cable Tie around the Temperature

Sensor wire to act as a strain relief. Clip off the excess length of Cable Ties. Attachment

to four different types of water inlet pipes are illustrated below. Plug this Temperature

Sensor into the "Cold Water Sensor" connector on the side of the Aquanta Controller

(see Item 4 on page 8).