Miller Welding 안전 퀵 매뉴얼 - 페이지 3
{카테고리_이름} Miller Welding에 대한 안전 퀵 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Welding 16 페이지. For arc welding and cutting the safe way
Miller Welding에 대해서도 마찬가지입니다: 소유자 매뉴얼 (33 페이지)
페이지 인쇄
Safety Quick-Guide
1. General Safe Practices
+
2. Arc Welding Hazards
ANSI Z49.1
OSHA 29CFR 1910
MSDSs
Owner's Manual
Wear approved safety glasses with side shields under your
welding helmet or face shield and at all times in the work area.
Read the equipment Owner's Manual for more complete safety
information.
Wear a safety harness if working above floor level.
Keep children away from all equipment and processes.
Do not install or place machine on or over combustible surfaces.
Have only qualified persons install, use, or service all equipment.
Electric shock from welding electrode or wiring
can kill.
Wear dry insulating gloves. Do not touch electrode with bare hand.
Do not wear wet or damaged gloves.
Do not touch live electrical parts.
Do not use AC weld output in damp, wet, or confined spaces.
Protect yourself from electric shock by insulating yourself from
work and ground. Use non-flammable, dry insulating material if
possible, or use dry rubber mats, dry wood or plywood, or other dry
insulating material big enough to cover your full area of contact
with the work or ground, and watch for fire.
Disconnect input plug or power before working on machine.
Do not make input connections if color blind.
Frequently inspect input power cord for damage or bare wiring —
repair or replace cord immediately if damaged. Be sure input
ground wire is properly connected to a ground terminal in
disconnect box or receptacle.
Properly install and ground all equipment according to its Owner's
Manual and national, state, and local codes.
Become trained and read the
instructions before working on the
machine or welding or cutting.
Read Material Safety Data Sheets
(MSDSs) for metals, consum-
ables, and coatings.
Page 2