Miller XMS 403 소유자 매뉴얼 - 페이지 25

{카테고리_이름} Miller XMS 403에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XMS 403 44 페이지. 400 volts ce arc welding power source

페이지 인쇄

4-8. Gas Selection in Synergic MIG or Synergic Pulsed MIG Welding

L13

Gas

L13 LED

P6 Push Button

Press P6 until gas LED illuminates. D1 and

D2 will show gas name momentarily. Rotate

4-9. Trigger Mode Selection (L-TIG and Stick Processes)

L14

L15

L16

L17

Always check and set a trigger mode.

If trigger mode is undefined for a weld-

ing process, select the desired mode.

L14 LED

L15 LED

L16LED

L17 LED

P7 Push Button

Trigger mode can be set for TIG only.

In TIG welding, pressing P7 will change the

trigger mode, but D1 and D2 will not change

values.

In Stick welding, pressing P7 will enable

welding (L17 ON, D1 shows open circuit

voltage (OCV) or weld voltage.

D2 displays pre-set welding current or actu-

E2 encoder to select desired gas type. After

a brief moment the the displays will return to

the main parameters.

Displays D1 and D2 will display NO

al welding current. If welding output is dis-

abled welding (L17 OFF, D1 displays

STICK and D2 displays set current).

Press P7 to select the desired trigger mode:

L14 ON selects 2T trigger mode.

When trigger is pressed, welding starts.

When trigger is released, welding stops.

L15 ON selects 4T trigger mode.

When trigger is pressed, welding starts at

initial current level (IN).

When trigger is released, welding current

increases to the set current level.

When trigger is pressed and held, welding

current decreases to the set final current

(FI-A) is achieved. Releasing trigger extin-

guishes welding arc.

L16 ON selects 3 levels trigger function.

Ref. 956142645-5-5

PROG or alternate selection will not be

possible when either process, material,

wire diameter, and shielding gas com-

bination is not permitted.

Ref. 956142645-5-5

When trigger is pressed, welding starts with

initial level of welding current (Level 1).

When trigger is released, welding current

increases to the set current level (Level 2).

When trigger is pressed a second time,

weld current decreases to the set current

level (Level 3) arc extinguishes.

During level 2 mode if the torch trigger is

pressed and held, welding current de-

creases to the set final-current level (FI-A).

Releasing trigger extinguishes welding arc.

L16 trigger mode is useful for thin mate-

rials and for a crater fill sequence.

L17 ON: Weld output power is enabled

welding terminals are electrically live. Stick/

TIG process requires LED L17 to be en-

abled. LED L17 will illuminate when welding

output power is enabling MIG mode.

OM-244 243 Page 21