Miller XR - Pistol - Pro 소유자 매뉴얼 - 페이지 23
{카테고리_이름} Miller XR - Pistol - Pro에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XR - Pistol - Pro 40 페이지. Air and water-cooled gun
페이지 인쇄7-2. Changing Gun Contact Tip
7-3. Gun Drive Assembly Maintenance
2
1
2
3
Remove nozzle
1
Nozzle
2
FasTip
Unscrew FasTip.
Install new FasTip.
Ref. 150 437-A
1
Lever Arm
Remove pressure on wire by
pulling lever arm forward. Pull to left
to lock into place.
Retract wire onto spool.
2
Drive Roll
Use wire brush to clean drive roll.
Install drive roll with hex opening
down toward shaft hex, and secure
with screw.
3
Pressure Roll
Thread welding wire through gun.
Engage feeder drive rolls. Press jog
switch until wire is sticking out end
of contact tip.
Close top cover.
1
Tools Needed:
7/64, 1/16 in.
3/8 in.
Ref. T0008 / T0025
OM-254 824 Page 19