Burkert 2300 Series 추가 지침 - 페이지 5
{카테고리_이름} Burkert 2300 Series에 대한 추가 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Burkert 2300 Series 12 페이지. Remote-positioner, installation on process valves with internal air flow
Burkert 2300 Series에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지), 빠른 시작 매뉴얼 (19 페이지)
페이지 인쇄
Type 8635, Remote-Positioner
Assembling the position sensor
NOTE!
Improper assembly may damage the lip seal in the guide
element.
The lip seal is pre-mounted in the guide element and must be
"locked into position" in the undercut.
▶ When assembling the switch spindle, do not damage the lip
seal.
→ Slide switch spindle through guide element.
→ To secure the switch spindle, apply a little screw locking paint
(Loctite 290) to the thread of the switch spindle.
→ Screw guide element into the actuator cover. Ensure that the
O-ring is positioned in the actuator cover.
→ Tighten guide element to 5 Nm.
→ Tighten switch spindle using a flat-tip screwdriver, maximum
torque 1 Nm.
2. Install sealing rings
→ Pull the form seal onto the actuator cover (smaller diameter
points upwards).
→ Check that the O-rings are correctly positioned in the pilot air
ports.
When the remote sensor is being installed, the collets of
the pilot air ports must not be fitted to the actuator.
Switch cam
Switch spindle complete
Guide element
Form seal
Fig. 4:
Actuator with installed switch spindle
3.2
Mounting remote position sensor on
the actuator
→ Unscrew body casing from the position sensor in a counter-
clockwise direction and remove.
Fig. 5:
Remote position sensor
english
Body casing
Connection housing
5