Miller XT30 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Miller XT30에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30 40 페이지. Air plasma cutting and gouging
Miller XT30에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지)

페이지 인쇄

General

Toppling or tilting

Torch −

The XT30 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 375

X-TREME. Do not use this torch in combination with any other machines.

Gas Type

Gas Quality

Gas Inlet Flow and Pressure

Gas Filtering

Mild Steel capacities (see Section 6-2 for cutting speeds vs material type and thickness)

Cooling Method

Duty Cycle of Torch

Rating of Electrical Controls (Trigger)

Rating of Electrical Controls (Cup)

Approved Systems

Trigger Protection

Safety Devices

Rated Capacity (edge start)

Sever Cut Capacity (edge start)

Pierce Capacity

*Travel speeds are approximately 80% of maximum.

Dimensions

Weight

Requirements for the torch connection

Use only compressed air which is free from dirt, oil, and water.

Ensure that the connections are properly assigned and tighened.

For torch replacement, see Miller torch manual Part No. OM-1593

Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.

4-3. Torch Dimensions And Weight

OM-253 555 Page 12

A complete Parts List is available at www.MillerWelds.com

Spectrum 375 X-TREME w/XT30

1-3/16 in.

(30 mm)

1-1/2 in.

2.2 lb (1.0 kg)

(38 mm)

Up to 15 incline

Air or Nitrogen

Clean, moisture−free,

oil−free

5.0 SCFM (142 L/min)

Particulates to 5 microns

Air

100% at 30 Amps

30 VDC at .1 Amps

30 VDC at 1 Amp

torch

Safety trigger guard

Safety interlock devices shut

down power source

3/8 in. at 18 ipm (457 mm/min)*

5/8 in.

3/16 in.

13-1/8 in. (333 mm) L

5-1/2 in. (140 mm) W

9 in. (229 mm) H

18 lb (8.2 kg) including torch

8-3/4 in.

(222 mm)

−−

90 PSI (621 kPa)

120 PSI (827 kPa)

Min

Max

−−

− −

−−

− −

Ref. 253 554-A