Miller XT30C 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Miller XT30C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30C 40 페이지.
Miller XT30C에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지)

4-2. Duty Cycle And Overheating

For Units Connected to a 115 Volt Circuit

or a 230 Volt Circuit:

35% Duty Cycle At 27 amperes, 92 volts DC

3-1/2 Minutes Cutting

Overheating

2.2 lb (1.0 kg)

Notes

A complete Parts List is available at www.MillerWelds.com

35% duty cycle

6-1/2 Minutes Resting

Minutes

1-3/16 in.

(30 mm)

1-1/2 in.

(38 mm)

Reduce Duty Cycle

8-3/4 in.

(222 mm)

Duty Cycle is percentage of 10 min-

utes that unit can cut at rated load

without overheating.

If unit overheats, thermostat(s)

opens, output stops, Temperature

trouble light goes On, and cooling

fan runs. Wait fifteen minutes for

unit to cool or temperature light to

go off. Reduce amperage or duty

cycle before cutting or gouging.

NOTICE − Exceeding duty cycle

can damage unit and void warranty.

sduty1 5/95 / 804 486-B

Ref. 253 554-A

Work like a Pro!

Pros weld and cut

safely. Read the

safety rules at

the beginning

of this manual.

OM-255 590 Page 13